Introduction

The replacement of this flash light bulb will be needed when flash mode isn't working.

Unscrew all visible screws indicated by red circles with a #00 Phillips driver.
  • Unscrew all visible screws indicated by red circles with a #00 Phillips driver.

  • Slide memory card cover and unscrew hidden screw underneath with a #00 Phillips driver.

Ajouter un commentaire

Remove the flat side panel by applying gentle pressure toward the bottom of the camera.
  • Remove the flat side panel by applying gentle pressure toward the bottom of the camera.

  • Remove the corner panel by applying pressure away from the shutter button.

  • The memory card cover will come off with the corner panel.

  • Remove the top panel by applying gentle pressure away from the shutter button.

Ajouter un commentaire

  • Remove screws beneath the top panel indicated by red circles with a #00 Phillips driver.

Ajouter un commentaire

  • Remove the front and back covers by pulling them straight apart.

Ajouter un commentaire

  • Remove the screw securing the shutter button to the camera frame.

  • Lift the shutter button to remove it.

Ajouter un commentaire

  • Remove the screws from the circuitry with a Phillips #000 driver.

  • Remove the screw connecting the flash housing to the camera frame with the same driver.

Ajouter un commentaire

  • Pull the flash housing away from the camera frame.

  • Cut the wires connecting the flash module to the circuitry.

  • Connect the new flash module to the circuitry with a soldering iron and electrical solder.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jade Withrow

Membre depuis le 08/02/2018

255 Réputation

2 tutoriels rédigés

Équipe

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 39