Introduction

This guide is assist you in the replacement of the LVDS Board by removing the back cover to reveal the LVDS Board.

Start by removing the screen bezel.
  • Start by removing the screen bezel.

  • Use a pair of spudgers to pry between the bezel and the rest of the monitor.

  • Ideally use plastic tools as this step could damage the edges of the screencover.

  • lay monitor on its back and pull off screen cover.

Ajouter un commentaire

Flip the monitor over so that it is face down.
  • Flip the monitor over so that it is face down.

  • Remove the single screw in the middle using a #2 Phillips screwdriver.

  • Remove the backing to reveal the Low Voltage Display Signal Board.

Ajouter un commentaire

  • Remove the 4 holding screws using a #0 Phillips screwdriver.

  • Lift the cover to expose the LVDS Board while taking care to prevent removal of the white fogged plastic cover. This plastic cover keeps the wire ribbons safe from accidental damage.

Ajouter un commentaire

  • Disconnect the input signal ribbon cable from the top of the board.

  • Disconnect the output signal ribbon cables by using a plastic sprudger to lift the connection lock.

  • Remove and replace the LVDS Board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order. Ensure the bezel completely snaps in place all around the monitor.

Équipe

Cal Poly, Team S11-G1, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S11-G1, Banghart Winter 2018

CPSU-BANGHART-W18S11G1

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 11

Total : 79