Introduction

This guide will assist you to open up the monitor and remove the motherboard. Useful if the monitor does not power on after replacing power supply, or is turning on/ off repeatedly.

Pièces

Aucune pièce nécessaire.

Start by removing the screen bezel.
  • Start by removing the screen bezel.

  • Use a pair of spudgers to pry between the cover and the rest of the monitor.

  • Ideally use plastic tools as this step could damage the edges of the screencover.

  • Lay monitor on its back and pull off screen cover.

Ajouter un commentaire

Flip the monitor over so that it is facedown.
  • Flip the monitor over so that it is facedown.

  • Remove the single screw in the middle using a #2 Phillips screwdriver.

  • Remove backing to reveal signal/power board in center.

Ajouter un commentaire

  • Ensure to grip the connection plugs when removing wires to prevent damage to wires.

  • Unplug wires connected to supply (one on the left and one on right).

  • Disconnect the signal ribbon cable.

  • Pull the motherboard shield off—it's adhered in place by tape, so some force may be needed.

Ajouter un commentaire

  • Lay piece upside down.

  • Use a #2 Phillips screwdriver to remove the two screws that secure the motherboard.

  • Lift the motherboard out of the metal shield.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order. Ensure the bezel snaps in place all around monitor.

Une autre personne a terminé cette réparation.

Melina

Membre depuis le 22/01/2018

124 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team S11-G1, Banghart Winter 2018 Membre de l'équipe Cal Poly, Team S11-G1, Banghart Winter 2018

CPSU-BANGHART-W18S11G1

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 11

Total : 101