Aller au contenu principal

Introduction

Use this guide to replace the disc drive in your Samsung UBD-KM85C.

Pièces

Aucune pièce spécifiée.

  1. On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.
    • On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.

  2. From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front. From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.
    • From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.

  3. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it. There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.
    • There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.

  4. Remove the cover from the device.
    • Remove the cover from the device.

  5. The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.
    • The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.

  6. The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws. The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.
    • The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.

  7. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs. The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.
    • The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.

  8. Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.
    • Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

James Edwards

Membre depuis le 01/02/2018

627 Réputation

5 tutoriels rédigés

Équipe

Baylor, Team S2-G1, Johnson Spring 2018 Membre de l'équipe Baylor, Team S2-G1, Johnson Spring 2018

BU-JOHNSON-S18S2G1

3 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 90