Pièces

Aucune pièce nécessaire.

Use a #0 Phillips head screwdriver to remove the four small black screws from the back of the device.
  • Use a #0 Phillips head screwdriver to remove the four small black screws from the back of the device.

  • To ensure you don't lose any tiny parts during the replacement process, place parts on the white magnetic sheet.

  • Once the screws have been removed, proceed to take off back cover.

Ajouter un commentaire

Now, proceed to lift the battery out and remove it.
  • Now, proceed to lift the battery out and remove it.

Ajouter un commentaire

  • Use a #0 Phillips screwdriver to remove the four small silver screws from the outside corners of the battery housing.

Ajouter un commentaire

  • Now gently pry the front cover off. A Black Spudger can be used to assist in the removal of the cover.

Ajouter un commentaire

  • Gently separate the mainboard from the battery housing. This may be difficult around the headphone jack. Use a spudger if necessary.

  • Pull the motherboard out and down away from the top of the phone.

Ajouter un commentaire

  • Peel off the small foam rectangle on the back of the mainboard and set to the side.

  • Peel off the black tape and set off to the side.

Ajouter un commentaire

  • Gently pry up the memory chip and replace it with the new one.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Lauren

Membre depuis le 13/02/2014

43 Réputation

2 tutoriels rédigés

Équipe

Ohio State, Team 1-4, Buehl Spring 2014 Membre de l'équipe Ohio State, Team 1-4, Buehl Spring 2014

OSU-BUEHL-S14S1G4

3 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 2

Total : 564