Introduction

Use this guide to replace the function set.

Pièces

Aucune pièce nécessaire.

  1. Place your thumb on the right side of the camera over the battery door.
    • Place your thumb on the right side of the camera over the battery door.

    • Slide the battery door to the right until the door lifts up.

  2. Remove and recycle old batteries.
    • Remove and recycle old batteries.

  3. Unscrew 6 Phillips screws using the #00 Phillips screwdriver. Two screws are on the left side of the camera. Two screws are on the right side of the camera.
    • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Open battery slot on the bottom of the camera by sliding the door to the right. Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.
    • Open battery slot on the bottom of the camera by sliding the door to the right.

    • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

  6. Insert spudger in the seam at the bottom of the camera. Gently separate the rear case from the front of the camera. Gently separate the rear case from the front of the camera.
    • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

  7. This step is only needed for the case and logic board replacement
    • This step is only needed for the case and logic board replacement

    • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

  8. This step is only needed for the case replacement.
    • This step is only needed for the case replacement.

    • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

    • Slide the battery door off of the hinge.

  9. Remove the function set strip by lifting it from the inside of the rear case. The function strip is now free from the camera.
    • Remove the function set strip by lifting it from the inside of the rear case.

    • The function strip is now free from the camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ariana Martinez

Membre depuis le 15/04/2010

50 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 24-24, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 24-24, Regan Spring 2010

CPSU-REGAN-S10S24G24

4 membres

6 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 3

Total : 2,425