Introduction

This guide will help you remove the button plate from the camera

Pièces

Aucune pièce nécessaire.

  1. Remove the five case screws with a Phillips #00 Screwdriver.
    • Remove the five case screws with a Phillips #00 Screwdriver.

    • Five 3.5mm Phillips Screws

    Ajouter un commentaire

  2. Gently lift up the back cover and set aside.
    • Gently lift up the back cover and set aside.

    Ajouter un commentaire

    • Gently lift up on the left side of the LCD and slowly pull it to the left side of the camera but do not remove entirely, there is a ribbon connector.

    • Be careful not to rip out the ribbon connector.

    Ajouter un commentaire

    • To clear the ribbon connection underneath the screen, lift up the black ribbon gate with the spudger.

    • Gently lift ribbon out of the gate and set screen aside.

    Ajouter un commentaire

    • There are five screws of three different sizes which need removal.

    • One 4.5mm screw

    • Four 3.5mm screws, one on the button side

    • One 5.5mm screws

    Ajouter un commentaire

    • Slowly lift metal tray to the right.

    • Be careful not to bend the screw tabs or rip out the ribbon cable.

    • Remove ribbon cable by using the spudger to lift up the black ribbon gate to release the ribbon

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Anthony Giardina

Membre depuis le 19/04/2010

20 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 7-10, Maness Spring 2010 Membre de l'équipe Cal Poly, Team 7-10, Maness Spring 2010

CPSU-MANESS-S10S7G10

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,098