Pièces

Aucune pièce nécessaire.

  1. Place the monitor face down.
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

    Ajouter un commentaire

  2. Remove two 11.5mm screws with a  #2 Phillips screwdriver.
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

    Ajouter un commentaire

    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

    Ajouter un commentaire

    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

      • There are four clips on each side, four on the top, and one on the bottom.

      • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

    Ajouter un commentaire

    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ted Hsueh

Membre depuis le 20/09/2012

170 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 16-56, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 316