Pièces

Aucune pièce nécessaire.

  1. Place the monitor face down.
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

  2. Remove two 11.5mm screws with a  #2 Phillips screwdriver.
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

  3. Using a  #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.
    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Pry the monitor using the plastic opening tool to release the clips holding the cover on. There are four clips on each side, four on the top, and one on the bottom. You may hear a loud snapping noise when releasing the clips.  Do not be alarmed, it is natural.
    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

  6. Using the  #2 Phillips screwdriver, remove the one 6mm screw. Unplug the indicated cable by pulling on the base.
    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

  7. Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.
    • Disconnect the two connectors to the speakers by gently pulling on the hard plastic straight up.

  8. Carefully peel the tape from the board.
    • Carefully peel the tape from the board.

  9. Flip the monitor so the screen is facing you.
    • Flip the monitor so the screen is facing you.

    • Using Phillips #2 screwdriver remove the four 6.25 mm screws securing the speakers:

  10. Carefully lift the speakers up.
    • Carefully lift the speakers up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Xenia Leon Rodriguez

Membre depuis le 26/09/2012

37 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 16-56, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 318