1. Place the monitor face down.
    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

    Ajouter un commentaire

  2. Remove two 11.5mm screws with a  #2 Phillips screwdriver.
    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

    Ajouter un commentaire

    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

    Ajouter un commentaire

    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

      • There are four clips on each side, four on the top, and one on the bottom.

      • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

    Ajouter un commentaire

    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

    Ajouter un commentaire

    • Use caution when removing the connectors as they can easily break when removing.

    • Disconnect the multi-pin connector at the top of the board by firmly grasping the connector and pulling to the side.

    • Disconnect the multi-pin connector that runs between the video motherboard and the power supply motherboard. Firmly grasp the connector and pull straight up.

    • A plastic opening tool can be used to assist in the removal of connectors.

    Ajouter un commentaire

    • Remove the two 3/16" hex head screws from the VGA connecter. Use a pair of needle nose pliers if a wrench is not available.

    Ajouter un commentaire

    • Remove the four 6.4mm #2 Phillips screws from the corners of the motherboard with a #2 Phillips screwdriver.

    Ajouter un commentaire

    • Lift the motherboard straight up to remove it from the back panel.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Taylor

Membre depuis le 26/09/2012

10 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 16-56, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 16-56, Forte Fall 2012

CPSU-FORTE-F12S16G56

5 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 495