Introduction

The purpose of this replacement guide is to remove the Sega plastic casing to expose the internal content for further repair.

Pièces

Aucune pièce nécessaire.

  1. Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
    • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

  2. Remove the two screws that attach the Genesis' connector to the rest of the console.
    • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

  3. Slide the lock tab to the left to separate the halves of the console.
    • Slide the lock tab to the left to separate the halves of the console.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Lift from the left side to remove the top of the case.
    • Lift from the left side to remove the top of the case.

  6. Using the spudger, pry the cover off of the Genesis attachment.
    • Using the spudger, pry the cover off of the Genesis attachment.

  7. Lift the top of the case to remove the cover.
    • Lift the top of the case to remove the cover.

  8. Remove the faceplate by pulling it up, then out.
    • Remove the faceplate by pulling it up, then out.

Conclusion

To reassemble the device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Ryan Kotzebue

Membre depuis le 07/10/2010

259 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 5-14, Maness Fall 2010 Membre de l'équipe Cal Poly, Team 5-14, Maness Fall 2010

CPSU-MANESS-F10S5G14

5 membres

6 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 3

30 derniers jours : 11

Total : 4,208