Introduction

A complete guide to replacing the main board.

Pièces

Aucune pièce nécessaire.

Place your device upside down and locate the two battery compartments.
  • Place your device upside down and locate the two battery compartments.

Ajouter un commentaire

Press on the tabs at the bottom of the battery covers then lift up to remove.
  • Press on the tabs at the bottom of the battery covers then lift up to remove.

  • Remove batteries if they are present.

Ajouter un commentaire

  • Remove the following screws:

    • Seven Phillips scres

    • One 4.5 mm Gamebit screw

Ajouter un commentaire

  • Use tweezers to take all other screws out.

Ajouter un commentaire

  • Gently open the case by unfolding it over the top of the Sega Game Gear.

  • Do not pull the back of the case away, as cables are connected between both sides.

Ajouter un commentaire

  • Carefully unplug the 2 white-tipped connectors on the top cover.

Ajouter un commentaire

  • Unscrew all the marked screws.

Ajouter un commentaire

  • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

Ajouter un commentaire

  • Place the logic board on a flat surface.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Brandon Page

Membre depuis le 15/04/2010

130 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 28-33, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 4

7 derniers jours : 32

30 derniers jours : 123

Total : 14,623