Introduction

How to repair the speakers of a Sega Game Gear.

Pièces

Aucune pièce nécessaire.

  1. Place your device upside down and locate the two battery compartments.
    • Place your device upside down and locate the two battery compartments.

    Ajouter un commentaire

  2. Press on the tabs at the bottom of the battery covers then lift up to remove.
    • Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Remove batteries if they are present.

    Ajouter un commentaire

    • Remove the following screws:

      • Seven Phillips scres

      • One 4.5 mm Gamebit screw

    Ajouter un commentaire

  3. Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    Répandez la magie de Noël
    Obtenez 12 $ de réduction sur les commandes de 50 $ ou plus avec le code FIXMAS12
    • Use tweezers to take all other screws out.

    Ajouter un commentaire

    • Gently open the case by unfolding it over the top of the Sega Game Gear.

    • Do not pull the back of the case away, as cables are connected between both sides.

    Ajouter un commentaire

    • Carefully unplug the 2 white-tipped connectors on the top cover.

    Ajouter un commentaire

    • Unscrew the 8 Phillips screws from the logic board.

    There are 2 additional screws to remove from the motherboard to the left and right of the cartridge port's shiny metal shield's screws on my Sega Game Gear with the RED GREEN and BLUE colors on the front.

    Karl Dusenbery - Réponse

    • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

    Ajouter un commentaire

    • Removing the plastic holding the speaker to the case may permanently detach the speaker.

    • The plastic at these three locations is melted to the plastic. Pry off with caution.

    Recommendations for the prying off process? It looks like a soldering iron was taken to the points to loosen the plastic but I'm not sure

    Navy Vet 2015 - Réponse

    I found that poking around the orange/redish posts with a hobby knife worked really well. Poke a small hole where the black plastic meets the red plastic and continue doing this around the post. Once you have done that it might help to go around the post a second time pressing more firmly as to push the knife just a little further. Use your finger or plastic prying tool to pry up each side. I wouldn't recommend just taking a prying tool to each post without breaking the connection between the posts and the retaining plate as you will potentially break the plate that holds the speaker in place. This is very easy to do but it is time consuming if you're concerned with keeping everything in as close to "new" condition as possible.

    Navy Vet 2015 -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Lauren Thurston

Membre depuis le 15/04/2010

296 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 28-33, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 10

30 derniers jours : 35

Total : 9,108