Réparez vos affaires Communauté Boutique

Sega Game Gear Speakers Replacement

Rédigé par : Lauren Thurston (et 9 autres contributeurs)
  • Commentaires : 7
  • Favoris : 5
  • Réparations terminées : 2

Difficulté

Modérée

Étapes

9

Sections

3

Drapeaux

0

Introduction

How to repair the speakers of a Sega Game Gear.

Outils

Pièces

Aucune pièce spécifiée.

Vidéo d'introduction

  1. Place your device upside down and locate the two battery compartments.

    • Place your device upside down and locate the two battery compartments.

    Modifier

  2. Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Press on the tabs at the bottom of the battery covers then lift up to remove.

    • Remove batteries if they are present.

    Modifier

  3. Remove the following screws:

    • Remove the following screws:

    • Six Phillips screws

    • One 4.5 mm Gamebit screw

    Modifier

  5. Use tweezers to take all other screws out.

    • Use tweezers to take all other screws out.

    Modifier

  6. Gently open the case by unfolding it over the top of the Sega Game Gear. Do not pull the back of the case away, as cables are connected between both sides.

    • Gently open the case by unfolding it over the top of the Sega Game Gear.

    • Do not pull the back of the case away, as cables are connected between both sides.

    Modifier

  7. Carefully unplug the 2 white-tipped connectors on the top cover. Carefully unplug the 2 white-tipped connectors on the top cover. Carefully unplug the 2 white-tipped connectors on the top cover.

    • Carefully unplug the 2 white-tipped connectors on the top cover.

    Modifier

  8. Unscrew the 8 Phillips screws from the logic board.

    • Unscrew the 8 Phillips screws from the logic board.

    Modifier

  9. Slide the logic board out from under the circular black fastener at the top-left corner of the case.

    • Slide the logic board out from under the circular black fastener at the top-left corner of the case.

    Modifier

  10. Removing the plastic holding the speaker to the case may permanently detach the speaker. The plastic at these three locations is melted to the plastic. Pry off with caution.

    • Removing the plastic holding the speaker to the case may permanently detach the speaker.

    • The plastic at these three locations is melted to the plastic. Pry off with caution.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Auteur

avec 9 autres contributeurs

Lauren Thurston

Membre depuis le 15/04/2010

397 Réputation

3 tutoriels rédigés

Badges: 15

+ 12 badges supplémentaires

Équipe

Cal Poly, Team 28-33, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 membres

13 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 13

30 derniers jours : 43

Total : 10,801