Introduction
Wireless controllers have many advantages over wired ones. However, these controllers will eventually run out of charge. This guide will show you how to replace the batteries in your controller.
Ce dont vous avez besoin
-
-
Using a Phillips #000 screwdriver, unscrew the single screw located on the battery cover. Remove the battery cover and set it aside.
-
-
-
-
If batteries are in the battery slots and need to be replaced, then remove the old batteries by pressing them in and compressing the spring until there is enough space to take them out.
-
Insert two fresh batteries into each one of the slots by pushing the indicated negative end of the battery against the spring.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Équipe
Cal Poly, Team S24-G12, Maness Spring 2018 Membre de l'équipe Cal Poly, Team S24-G12, Maness Spring 2018
CPSU-MANESS-S18S24G12
4 membres
10 tutoriels rédigés
Un commentaire
any idea where i can find a schematic for the contoller board. I just bought one of these second hand and the wireless controller won’t connect to the system. I took it apart and it’s missing a small resistor.
