Introduction

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

Pièces

Aucune pièce nécessaire.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

    Ajouter un commentaire

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

    Ajouter un commentaire

    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

    Ajouter un commentaire

    • Bend out the LED leads into vertical positions.

    Ajouter un commentaire

    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

    Ajouter un commentaire

    • Separate the main board from the outer case.

    Ajouter un commentaire

    • Using Philips screwdriver, remove 11 screws securing silver casing.

    Ajouter un commentaire

    • Remove silver case.

    Ajouter un commentaire

    • Locate reset button on motherboard

    Ajouter un commentaire

    • Place three pieces of 1cm x 1cm masking tape over reset button.

    You could also, if you feel confident in your skills, desolder the old button and replace it with a standard 4-pin pushbutton. Resolder the new one, and it should work.

    Tsaku - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

Une autre personne a terminé cette réparation.

calvin

Membre depuis le 05/10/2010

186 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 3-29, Regan Fall 2010 Membre de l'équipe Cal Poly, Team 3-29, Regan Fall 2010

CPSU-REGAN-F10S3G29

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 19

30 derniers jours : 68

Total : 11,463