Introduction

This guide will show you how to take apart the fan to remove the Printed Circuit Board.

Pièces

Aucune pièce nécessaire.

Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.
  • Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.

  • Do this by unscrewing from left-to-right then pull the screws out of the back of the fan

Ajouter un commentaire

Pull the front and back cover apart.
  • Pull the front and back cover apart.

  • Be careful not to pull the front cover off completely because it holds the wires.

Ajouter un commentaire

  • Remove the Phillips (5-mm head) 6-mm screw that holds the circuit board to the outer shell of the fan.

  • Make sure the fan is unplugged while removing the circuit board as you may get shocked.

  • To remove the screws, unscrew in a left-to-right fashion at an angle to make sure that the wires do not get tangled.

Ajouter un commentaire

  • Remove the top cover containing the circuit board and the wires by pulling it away from the body of the fan.

Ajouter un commentaire

  • Remove the circuit board from the top cover. Do not touch the other side of the circuit board as you may damage circuit elements.

  • Unscrew the four screws on the top of the circuit board in a left-to-right fashion. After pull screws out of the board.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mateo Begue

Membre depuis le 26/09/2012

78 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 15-46, Forte Fall 2012 Membre de l'équipe Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 5

30 derniers jours : 12

Total : 795