Introduction

This guide will start with opening the front panel. This will expose the control panel and more screws for further disassembly. Before doing any disassembly on your Shark Professional Steam Pocket Mop, make sure to unplug both the mop and empty the water tank for your safety.

Cette vue éclatée n'est pas un tutoriel de réparation. Pour réparer votre Shark Professional Steam Pocket Mop, utilisez notre manuel de réparation.

Unwrap the power cord from the handle.
  • Unwrap the power cord from the handle.

  • Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.

  • Pull the handle to separate it from the body.

Ajouter un commentaire

Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.
  • Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.

  • Remove the plastic cap.

Ajouter un commentaire

  • Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.

  • The third screw is directly on other side of the bottom screw in the photo.

Ajouter un commentaire

  • Remove steam control button cover with a metal spudger.

  • Remove the two 12.0 mm Phillips head #2 screws underneath.

  • Remove the plastic rim with clear plastic cover.

Ajouter un commentaire

  • Remove the Shark logo decal on the front of body using a metal spudger.

  • Remove the two 12.0 mm Phillips head #2 screws underneath.

  • Pull out the plastic cover to remove.

Ajouter un commentaire

  • Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

Ajouter un commentaire

Brett Wilson

Membre depuis le 12/02/2018

773 Réputation

6 tutoriels rédigés

Équipe

USF Tampa, Team S15-G1, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S15-G1, Boczar Spring 2018

USFT-BOCZAR-S18S15G1

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 7

30 derniers jours : 40

Total : 421