Introduction

If one of the components on the motherboard is damaged, it is easier to replace the whole motherboard. Gaining access to the motherboard requires disassembling the vacuum. This guide will demonstrate how to remove the motherboard of your Shark Rocket Powerhead AH401.

Pièces

Aucune pièce nécessaire.

Ensure the device is turned off and unplugged from any power source before beginning work.
  • Ensure the device is turned off and unplugged from any power source before beginning work.

  • Locate the two tabs with white arrows on them. They are located on either side of the brushroll cover.

  • Slide the tabs away from the center of the vacuum to unlock the brushroll cover.

  • Lift the brushroll cover upward.

Ajouter un commentaire

Lift the brushroll out by pulling the tab labeled "pull".
  • Lift the brushroll out by pulling the tab labeled "pull".

Ajouter un commentaire

  • Ensure the device is turned off and unplugged from any power source before beginning work.

  • Push down on the dust can lever to release the dust can in order to get to the filter grill.

Ajouter un commentaire

  • Remove the dust cup by lifting it off the dock.

Ajouter un commentaire

  • Flip the device over so that the bottom is face up.

  • Remove the eight screws shown by rotating counter-clockwise with a T15 Torx screwdriver.

    • Two 14 mm Torx screws

    • Two 16 mm Torx screws

    • Four 21 mm Torx screws

Ajouter un commentaire

  • Remove the three 10mm screws by rotating counter clockwise with a T15 Torx screwdriver.

  • Remove the airpath grille by gently lifting up and away from the motor compartment.

Ajouter un commentaire

  • Remove two 14mm screws by rotating counter-clockwise with a T15 Torx screwdriver.

Ajouter un commentaire

  • Lift and gently remove the hinge compartment covering the motherboard.

Ajouter un commentaire

  • Remove the two 10mm screws by rotating counter-clockwise with a T10 Torx screwdriver

Ajouter un commentaire

  • Lift the motherboard out of its compartment.

Ajouter un commentaire

  • Locate and remove these connections by pulling the plugs out of the sockets.

Ajouter un commentaire

  • Flip the motherboard over to reveal the wires underneath.

  • Locate and cut all the wires connected to the motherboard using cutting pliers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Shobhit Dabral

Membre depuis le 24/01/2018

712 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team S19-G3, Livingston Winter 2018 Membre de l'équipe Cal Poly, Team S19-G3, Livingston Winter 2018

CPSU-LIVINGSTON-W18S19G3

4 membres

9 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 63