Introduction

This guide will inform users how to remove and replace their Shark Steam Pocket Mop's ejection button assembly.

Pièces

Aucune pièce nécessaire.

Begin by removing the 8 quarter inch phillips head screws found along the back panel
  • Begin by removing the 8 quarter inch phillips head screws found along the back panel

  • Once all 8 screws have been removed, gently remove the back panel from the rest of the mop's body

Ajouter un commentaire

Begin by removing the two quarter inch Phillips head screws you see pictured. These screws hold the bottom part of the button assembly to the Mop's midframe.
  • Begin by removing the two quarter inch Phillips head screws you see pictured. These screws hold the bottom part of the button assembly to the Mop's midframe.

  • Be very careful not to lose the spring that is in between the top and bottom part of the button assembly.

Ajouter un commentaire

  • Once the bottom piece of the assembly has been removed, carefully turn the mop over and move the front panel of the mop to the side

  • Once you've turned your device over you should be able to remove the top portion of the button assembly with ease. It should not require anything more than your fingers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jacob Howe

Membre depuis le 10/10/2017

501 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S13-G7, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S13-G7, Cagle Fall 2017

USFT-CAGLE-F17S13G7

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 5

Total : 51