Introduction

This guide will inform users how to replace their Shark Steam Pocket Mop's Water Tank / Bladder.

Pièces

Aucune pièce nécessaire.

Begin by removing the 8 quarter inch phillips head screws found along the back panel
  • Begin by removing the 8 quarter inch phillips head screws found along the back panel

  • Once all 8 screws have been removed, gently remove the back panel from the rest of the mop's body

Ajouter un commentaire

Start by gently moving the midframe from the top portion of the panel to expose the bottom portion of the mop's water tank / bladder.
  • Start by gently moving the midframe from the top portion of the panel to expose the bottom portion of the mop's water tank / bladder.

Ajouter un commentaire

  • Remove the 10 quarter inch phillips head screws from the bottom portion of the water tank / bladder.

  • Then gently lift the water tank / bladder out of its plastic housing. and turn it over.

  • To fully remove the water tank / bladder, use your tweezers to remove the metal ring that keeps the hose fastened to the plastic tank.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jacob Howe

Membre depuis le 10/10/2017

501 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S13-G7, Cagle Fall 2017 Membre de l'équipe USF Tampa, Team S13-G7, Cagle Fall 2017

USFT-CAGLE-F17S13G7

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 10

Total : 74