Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
While holding the microphone connector in one hand, and the XLR cable in the other hand, slowly pull them apart.
-
Check to make sure all of the internal wires are connected. If you see a disconnected wire, take a look at the connector soldering guide.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Hold the microphone connector in one hand and the microphone base in the other.
-
Line up the screw in the connector with the hole in the middle of the microphone.
-
Also, align the ridge on the microphone connector (located near the top of the connector) with the slot in the base of the microphone.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With those parts aligned, push the connector back into the microphone until the screw lines up with hole in the side of the microphone.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a small flat head screw driver, turn the screw in the side of the microphone clockwise until it is tight.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
2 commentaires
you can buy the part here
simple clear and precise. Small problem fixed in no time, thank you very much!