Introduction

Buttons might tear and get worn out so it is important to replace the buttons.

Pièces

Aucune pièce nécessaire.

  1. Wedge a plastic opening tool in between the case.
    • Wedge a plastic opening tool in between the case.

  2. Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device. You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device. You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.
    • Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.

    • You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.

  3. Once unclipped, separate the back casing from the device.
    • Once unclipped, separate the back casing from the device.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Remove the three 5mm JIS #00 screws from the motherboard. Remove the three 5mm JIS #00 screws from the motherboard.
    • Remove the three 5mm JIS #00 screws from the motherboard.

  6. Unlatch the two clips that hold the motherboard in place.
    • Unlatch the two clips that hold the motherboard in place.

  7. Lift the motherboard up and out of the frame.
    • Lift the motherboard up and out of the frame.

  8. Holding the front casing in your hand, push the button panels out of the casing. There are two buttons panels: Navigation panel and the Channel Number panel
    • Holding the front casing in your hand, push the button panels out of the casing.

    • There are two buttons panels: Navigation panel and the Channel Number panel

Conclusion

To reassemble your device, follow these instructions in reverse order.

Angel Rivera

Membre depuis le 25/01/2018

505 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S7-G2, Passmore Spring 2018 Membre de l'équipe USF Tampa, Team S7-G2, Passmore Spring 2018

USFT-PASSMORE-S18S7G2

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 3

Total : 44