Réparez vos affaires Communauté Boutique

Skullcandy Air Raid Buttons Replacement

Introduction

This disassembly includes the button panel and button motherboard.

Ce dont vous avez besoin

  1. Skullcandy Air Raid Buttons Replacement, Rubber Cover: étape 1, image 1 de 1

    • Starting with the corners, gently pull the rubber cover off of the device.

    Modifier

  2. Skullcandy Air Raid Buttons Replacement, Handle: étape 2, image 1 de 1

    • Using the T-6 hexagonal screwdriver, unscrew the four 10mm #6 hex screws on the right side of the device.

    • Remove the handle from the device.

    Modifier

  3. Skullcandy Air Raid Buttons Replacement, Front Plate: étape 3, image 1 de 1

    • Unscrew the two screws on the left side of the device using the phillips #00 screwdriver.

    • One 5mm Phillips screw.

    • One 8mm Phillips screw.

    Modifier

  5. Skullcandy Air Raid Buttons Replacement: étape 4, image 1 de 1

    • Gently pull the sides of the front plate outwards from the device.

    • Pull up on the front plate to remove it from the device.

    Modifier

  6. Skullcandy Air Raid Buttons Replacement, Control Buttons: étape 5, image 1 de 2 Skullcandy Air Raid Buttons Replacement, Control Buttons: étape 5, image 2 de 2

    • Using a Phillips #00 Precision Screwdriver, unscrew two 6 mm screws from the middle of the panel, specifically above and below the volume buttons.

    • Lift the button panel.

    Modifier

  7. Skullcandy Air Raid Buttons Replacement, Button Motherboard: étape 6, image 1 de 1

    • Using a Phillips #00 Precision Screwdriver, unscrew two 6 mm screws from the button motherboard.

    Modifier

  8. Skullcandy Air Raid Buttons Replacement: étape 7, image 1 de 1

    • Using a plastic opening tool, pry up on the button motherboard to detach it from the device.

    • The button motherboard is connected to a ribbon cable inside the device.

    Modifier

  9. Skullcandy Air Raid Buttons Replacement, Ribbon Cable: étape 8, image 1 de 1

    • First, pull on the black attachment to disconnect it from the metal piece.

    • Release the cable from the back of the motherboard.

    • The black attachment is a part of the connector, not the blue ribbon cable. It will not disconnect from the motherboard.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autres ont terminé cette réparation.

Auteur

avec 3 autres contributeurs

Sasha Nevin

Membre depuis le 01/13/15

257 Réputation

1 tutoriel rédigé

Badges: 12

+ 9 badges supplémentaires

Équipe

Eastern Washington University, Team 1-3, Carnegie Winter 2015 Membre de l'équipe Eastern Washington University, Team 1-3, Carnegie Winter 2015

EWU-CARNEGIE-W15S1G3

3 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 7

30 derniers jours : 10

Total : 1,290