Skytex Skypad Alpha 2 Antenna Replacement

Introduction

By following this guide one is able to access the antenna of the Skypad Skytex Alpha 2 tablet in two steps. These steps include removing any metallic tape that holds the antenna and removing soldered connections.

Ce dont vous avez besoin

Étape 1 Back Cover

Skytex Skypad Alpha 2 Antenna Replacement, Back Cover: étape 1, image 1 de 1

Power off the tablet.
Unplug the tablet from the power source if it is connected.

Modifier

Étape 2

Remove the (4) 3.5mm screws using a phillips #000 screwdriver.

Modifier

Étape 3

Use the plastic opening tool to work your way around the tablet, releasing the back case from the tabs.

Modifier

Étape 4

Release the back case from the rest of the tablet with your hand.
Do not pry the case too hard; doing so can damage the tablet.

Modifier

Étape 5 Antenna

Skytex Skypad Alpha 2 Antenna Replacement, Antenna: étape 5, image 1 de 1

Remove the metallic electrical tape, just enough, to allow the antenna to hang freely.
Remove all black and yellow tape, if necessary, on the motherboard.

Modifier

Étape 6

Remove the soldered connections to separate the antenna wire from the motherboard.
The antenna wire will be connected to the motherboard with 2 connections, so be sure to remove both with the soldering iron.
Follow the link below for further soldering information: How To Solder and Desolder Connections.
Soldering irons require a large amount of heat; use caution when performing this step. Excessive heat can damage parts of your device; do not leave the soldering iron on connections for extended periods of time.

Modifier

Étape 7

Outil utilisé dans cette étape :

Tweezers

$4.99

J'achète

Remove the antenna from the tablet using a pair of tweezers.
The antenna is actually fastened inside the back case of the tablet, pull gently to free it from the adhesive.