Introduction

We turn our devices on and off every single day, and as such, the buttons wear over time. This repair guide will focus on replacing the electrical components controlling the On/Off buttons.

Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
  • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

Ajouter un commentaire

Use a plastic opening tool to pry the cover open.
  • Use a plastic opening tool to pry the cover open.

  • After the the cover is partly open as shown, remove the cover with your hands.

Ajouter un commentaire

  • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

Ajouter un commentaire

  • Use a plastic opening tool to loosen the back cover off the device.

  • Once the back cover is loose, remove it gently by hand.

Ajouter un commentaire

  • Using a spudger, carefully remove the metal casing that is attached to the ZIF connector.

Ajouter un commentaire

  • Unclip the two plastic buttons with the spudger tool.

  • The buttons each have a spring under them that will fall off, be careful not to lose them.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Fred Saucedo

Membre depuis le 11/01/2013

3 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 7-12, Maness Winter 2013 Membre de l'équipe Cal Poly, Team 7-12, Maness Winter 2013

CPSU-MANESS-W13S7G12

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 212