Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove two 4.9mm Phillips #00screws on the front of the device.
-
Remove two 7.5mm Phillips #00screws on the front of the device.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Rotate device 90 degrees to either side.
-
Use the plastic opening tool to pry open the top and bottom tab respectively.
-
Repeat on opposite side.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove four 11.5mm Phillips #00 (silver) screws from back panel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove four 9.5mm Phillips #00 (black) screws from back panel.
-
Remove two 7.5mm Phillips #00 (black) screws from back panel.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove one 9.5mm Phillips #00 screw.
-
Rotate device 180 degrees and repeat step.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using plastic opening tool, detach the tabs. There are two on either side.
-
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Un commentaire
This guide is listed as "difficult" yet only requires the use of a screwdriver and some prying tools. It would seem more appropriate to list it as "moderate" at most. I believe the motherboard guide has the same issue.
Also, you say PH#00 in the description of steps, but in the "tools" listing at the beginning of the guide, you said that a PH#0 was needed. These are not the same.