This guide will show how to replace a motherboard. The motherboard could be causing faulty display, not turning on, and bad sound quality on a continuous basis.

Before any repair work can be done, one must remove the device from the vehicle. To do so follow this link to see a vehicle general removal of a stereo system.


Aucune pièce nécessaire.

Locate face-plate eject button.
  • Locate face-plate eject button.

Ajouter un commentaire

Press the eject button.
  • Press the eject button.

  • Remove the face-plate.

Ajouter un commentaire

  • Remove two 4.9mm Phillips #00screws on the front of the device.

  • Remove two 7.5mm Phillips #00screws on the front of the device.

  • When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.

The screws in red do not seem to need to be removed unless you are trying to replace the eject lever. If you're not trying to replace the lever, it adds an unnecessary complication to putting it back together.

Dale Pearson - Réponse

  • Rotate device 90 degrees to either side.

  • Use the plastic opening tool to pry open the top and bottom tab respectively.

  • Repeat on opposite side.

Ajouter un commentaire

  • Remove front panel.

Ajouter un commentaire

  • Locate the clip on the wiring harness.

Ajouter un commentaire

  • Press down on the clip like you would an Ethernet cable.

  • Rock harness side to side, pulling gently towards you until harness detaches.

Ajouter un commentaire

  • Locate back panel.

Ajouter un commentaire

  • Remove four 11.5mm Phillips #00 (silver) screws from back panel.

Ajouter un commentaire

  • Remove four 9.5mm Phillips #00 (black) screws from back panel.

  • Remove two 7.5mm Phillips #00 (black) screws from back panel.

Ajouter un commentaire

  • Remove back panel.

  • On the back panel there will be thermal (white) paste. Do not touch.

Ajouter un commentaire

  • Remove one 9.5mm Phillips #00 screw.

  • Rotate device 180 degrees and repeat step.

Ajouter un commentaire

  • Using plastic opening tool, detach the tabs. There are two on either side.

  • You will need to apply a decent amount of force to detach.

Ajouter un commentaire

  • Remove top panel.

Ajouter un commentaire

  • Pull up CD drive slightly.

Ajouter un commentaire

  • Disconnect motherboard connection.

Ajouter un commentaire

  • Remove CD drive.

Ajouter un commentaire

  • Remove three 6.7mm Phillips 300 screws.

Ajouter un commentaire

  • Pull motherboard up.

Ajouter un commentaire


To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Odelkys Marquez

Membre depuis le 22/09/2014

922 Réputation

7 tutoriels rédigés


USF Tampa, Team 10-2, Brown Fall 2014 Membre de l'équipe USF Tampa, Team 10-2, Brown Fall 2014


3 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 8

Total : 899