Introduction

The Sony Clie PEG-UX50 has a separate tilt screen mechanism that does not require the user to dismantle the battery plate in order to get to the display .

Pièces

Aucune pièce nécessaire.

  1. Take off the screws located on the 2 sides of the tilt screen.
    • Take off the screws located on the 2 sides of the tilt screen.

    • Unscrew the screw located at the tilt base of the screen

    Ajouter un commentaire

  2. Gently remove back plate of tilt screen by sliding upward.
    • Gently remove back plate of tilt screen by sliding upward.

    • With caution, lift wires from the track in the back plate

    Ajouter un commentaire

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Disconnect the thin bus cable attached to the Integrated Circuit

    Ajouter un commentaire

    • Detach the plastic black frame from in between the plate and lcd.

    • Do not disconnect the display from the board yet.

    Ajouter un commentaire

    • Disconnect the thin connector from the face plate using the tweezer

    Ajouter un commentaire

    • With your hands, quick-release and disconnect the thick cable

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rishad R Rai

Membre depuis le 28/04/2011

1 Réputation

1 tutoriel rédigé

Équipe

CSU Los Angeles, Team 1-4, Nelson Spring 2011 Membre de l'équipe CSU Los Angeles, Team 1-4, Nelson Spring 2011

CSULA-NELSON-S11S1G4

5 membres

2 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 2,274