Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

If you are confident that your motherboard needs to be replaced, and have a replacement motherboard, then follow this guide.

  1. Open the battery compartment and remove the batteries.
    • Open the battery compartment and remove the batteries.

    • Remove all of the visible screws on the outside of the case.

    • There should be three of them that are all easily located.

  2. Open the memory card compartment.
    • Open the memory card compartment.

    • Remove the screw next to the memory card slot.

  3. Pull apart the front and back cover pieces carefully.
    • Pull apart the front and back cover pieces carefully.

    • The front cover should come completely free with little effort.

    • The back cover will still be attached to the circuit board.

  4. Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.
    • Simultaneously unclip all of the clips holding in the circuitry. Remove the back case.

    • The circuitry will still be connected to the back case by ribbon cables.

  5. Manta Precision Bit Set

    112 embouts pour toute réparation.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  6. Open the case as shown.
    • Open the case as shown.

  7. Unclip the clip holding the ribbon cable in.
    • Unclip the clip holding the ribbon cable in.

    • Other ribbon cables might not have a clips.

  8. Pull the ribbon cable out.
    • Pull the ribbon cable out.

  9. Remove all six screws on the front side of the motherboard circled in the picture.
    • Remove all six screws on the front side of the motherboard circled in the picture.

    • Pull the motherboard from the rest of the housing.

    • It will still be connected to the flash unit.

  10. Remove the cable on the back side of the motherboard.
    • Remove the cable on the back side of the motherboard.

  11. Detach the ribbon cables shown.
    • Detach the ribbon cables shown.

    • Careful! Touching the leads of the large yellow capacitor can result in a painful shock.

    • Remove the flash unit from the motherboard.

  12. The motherboard is now free, and ready to be replaced by a new one.
    • The motherboard is now free, and ready to be replaced by a new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Trevor

Membre depuis le 20/01/2011

277 Réputation

6 tutoriels rédigés

Équipe

Cal Poly, Team 3-43, Regan Winter 2011 Membre de l'équipe Cal Poly, Team 3-43, Regan Winter 2011

CPSU-REGAN-W11S3G43

4 membres

10 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 931