Pièces

Aucune pièce nécessaire.

  1. Slide the battery latch down the side of the camera with your hands.
    • Slide the battery latch down the side of the camera with your hands.

    • The latch will automatically pop open.

  2. Unlatch the clip over the battery.
    • Unlatch the clip over the battery.

    • The battery will partially pop out.

  3. Remove the battery from the camera. Remove the battery from the camera.
    • Remove the battery from the camera.

  4. %Livraison gratuite pour toute commande supérieure à 100 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique
  5. Unscrew the four 3.0mm Phillips #000 screws holding the back case onto the camera; there are two screws on top and two on the bottom.
    • Unscrew the four 3.0mm Phillips #000 screws holding the back case onto the camera; there are two screws on top and two on the bottom.

  6. Pull the back case gently away from the rest of the camera. Pull the back case gently away from the rest of the camera.
    • Pull the back case gently away from the rest of the camera.

  7. Remove the two 3.0mm Phillips #000 screws holding the display to the metal backing.
    • Remove the two 3.0mm Phillips #000 screws holding the display to the metal backing.

  8. Unlatch the display by sliding it towards the circuit board. Unlatch the display by sliding it towards the circuit board.
    • Unlatch the display by sliding it towards the circuit board.

  9. Remove the two ribbon cables attached to the circuit board by gently pulling them out of their slots.
    • Remove the two ribbon cables attached to the circuit board by gently pulling them out of their slots.

    • Be careful not to rip the ribbon cables while disconnecting them.

  10. The LCD is now separated from the camera.
    • The LCD is now separated from the camera.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jenna Crawford

Membre depuis le 09/04/2012

29 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 17-25, Amido Spring 2012 Membre de l'équipe Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 735