Pièces

Aucune pièce nécessaire.

  1. Slide the battery latch down the side of the camera with your hands.
    • Slide the battery latch down the side of the camera with your hands.

    • The latch will automatically pop open.

    Ajouter un commentaire

  2. Unlatch the clip over the battery.
    • Unlatch the clip over the battery.

    • The battery will partially pop out.

    Ajouter un commentaire

    • Remove the battery from the camera.

    Ajouter un commentaire

    • Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver.

    • Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.

    Ajouter un commentaire

    • Once the screws are removed, slowly remove the back casing from the rest of the camera.

    Ajouter un commentaire

    • Then, pull the front case away from the rest of the camera.

    Ajouter un commentaire

    • After the casing is removed, the camera should look as shown.

    Ajouter un commentaire

    • Dislodge the round casing from the lens.

    • Pull it away from the rest of the camera.

    Ajouter un commentaire

    • Unscrew the two 4.0mm Phillips #000 screws from the display.

    Ajouter un commentaire

    • Pull the two ribbon cables out of their slots on the back circuit board.

    Ajouter un commentaire

    • Remove the three 4.0mm Phillips #000 screws holding the back panel in place.

    Ajouter un commentaire

    • Work the back panel out from under the small grey clip.

    • Slide the back panel off of the camera by dislodging it from the remaining clips.

    • Below is a flat, orange cable connecting the lens to the motherboard.

    • Be careful not to bend the back plate during this process.

    Ajouter un commentaire

    • Turn the camera over so that you can see the front of the lens.

    • Two connectors link the lens to the motherboard.

    • Gently bring the lens away from the camera.

    Ajouter un commentaire

    • Using the flat end of the plastic spudger tool, flip up the black tabs on the connectors.

    • Be careful not to exert too much force, as the connectors are delicate.

    Ajouter un commentaire

    • Gently pull out the cables and move the lens away from the rest of the camera.

    • You should now have two distinct, separate components.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Sean Sayles

Membre depuis le 09/05/2012

7 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 17-25, Amido Spring 2012 Membre de l'équipe Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 1

Total : 1,051