Aller au contenu principal

Introduction

The flash bulb is the component of the camera responsible for illuminating the surroundings of the images. Replacing the flash bulb will require the removal of battery and black plastic housing that holds the CCD chip.

Pièces

Aucune pièce spécifiée.

  1. Locate the cover on the bottom of the camera.
    • Locate the cover on the bottom of the camera.

    • Slide the cover towards the back of the camera.

    • Be careful—the battery can slide out on its own.

  2. Carefully remove the exposed battery.
    • Carefully remove the exposed battery.

    • If it is difficult to remove, flip over the camera and the battery will slide out.

  3. Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver. Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver. Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.
    • Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.

  4. Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now

    Fix Kits pour batteries d'iPhone

    Seulement $29.99

    Buy Now
  5. Pull the two halves of the camera apart.
    • Pull the two halves of the camera apart.

    • Place the two halves down with the insides facing you.

  6. Find the two clips holding the motherboard to the black lens box.
    • Find the two clips holding the motherboard to the black lens box.

    • Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it. (If difficult, your fingernail can also be used)

  7. After releasing the clips, pull out black lens box.
    • After releasing the clips, pull out black lens box.

  8. Use the plastic opening tool to flip the clip. Use the plastic opening tool to flip the clip.
    • Use the plastic opening tool to flip the clip.

  9. Grab the white part and slide it to the right until it clicks. This may require some force.
    • Grab the white part and slide it to the right until it clicks.

    • This may require some force.

    • Pull out the flash.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Paul Elrich

Membre depuis le 12/04/2012

18 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 7-35, Maness Spring 2012 Membre de l'équipe Cal Poly, Team 7-35, Maness Spring 2012

CPSU-MANESS-S12S7G35

4 membres

3 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 1

Total : 536