Introduction

Taking out the LCD is one of the more difficult things to do on your Cyber-shot. Because the LCD is located at the back of the camera you will have to take apart the entire camera just to reach it.

Locate the battery door at the bottom of the camera.
  • Locate the battery door at the bottom of the camera.

  • Press down on the door and slide it back. The door will pop open.

Ajouter un commentaire

Remove the battery from the door that you opened in the previous step.
  • Remove the battery from the door that you opened in the previous step.

Ajouter un commentaire

  • There are two screws on the left and right sides of the camera, and two screws on the bottom.

  • Use a PH00 screwdriver and remove the six 2.9mm screws.

Ajouter un commentaire

  • Use hands to gently pry the front casing away from the camera.

Ajouter un commentaire

  • Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.

  • The second picture shows what these tabs look like in their open positions.

Ajouter un commentaire

  • Grasp the CCD Sensor Module and remove it.

Ajouter un commentaire

  • Use tweezers to slide the white piece on the back of the back cover to the right.

  • This will dislodge the white piece, allowing you to remove it from the back cover.

Ajouter un commentaire

  • Use the tip of a spudger to flip up the tab on the ZIF connector securing the motherboard ribbon cable.

  • Remove the ribbon cables from these two ZIF connectors.

Ajouter un commentaire

  • Lift the motherboard assembly up and rotate it so you can easily see where the internals connect to the back cover.

  • Remove the ZIF connectors from the clamp on the left end of the top piece.

  • The motherboard assembly is now separated from the back cover.

Ajouter un commentaire

  • Use a PH00 screwdriver to remove the 2.9 mm phillips screw on the upper left side of the case.

Ajouter un commentaire

  • Remove the back frame from the LCD assembly.

  • Turn the LCD assembly over and gently pull the top bar off (which has the shutter and power buttons).

Ajouter un commentaire

  • Pull the tape off that holds the LCD to the assembly.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

iDeleted

Membre depuis le 07/07/2010

2 101 Réputation

41 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 5

Total : 3,627