Réparez vos affaires

Droit à la réparation

Pièces & Outils

Sony Cyber-shot DSC-W5 Speaker Replacement

Rédigé par : Thomas (et 6 autres contributeurs)
  • Commentaires : 2
  • Favoris : 0

Difficulté

Modérée

Étapes

12

Sections

3

Drapeaux

1

Incorrect Tools

Outils incorrects

Participez à l'amélioration de ce tutoriel en utilisant les outils adaptés dans les photos et/ou le texte.

Introduction

Steps on how to replace the speaker.

  1. Remove Memory Stick Pro from the card reader slot on the bottom of the camera.

    • Remove Memory Stick Pro from the card reader slot on the bottom of the camera.

    • Remove both batteries.

    Traduire

  2. Remove the single visible screw from both sides of the camera. Remove the two screws that are adjacent to the warning label, which is on the underside of the camera.

    • Remove the single visible screw from both sides of the camera.

    • Remove the two screws that are adjacent to the warning label, which is on the underside of the camera.

    • Do NOT remove all four screws from the bottom.

    Traduire

  3. Gently remove the back cover from the camera. The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free.

    • Gently remove the back cover from the camera.

    • The first time the case is removed, it will be stiff. Be patient and gently rock the cover back and forth until it slides free.

    Traduire

  4. Remove the two screws holding the circuit board down. Remove the two screws holding the circuit board down.

    • Remove the two screws holding the circuit board down.

    Traduire

  6. Detach the orange cable from the board.

    • Detach the orange cable from the board.

    • Use a thin object, like a paperclip, to gently pry the cable off the connector.

    Traduire

  7. The LCD screen sits in two slots; one on the bottom, and one on the left edge. Slide LCD screen from the two slots.

    • The LCD screen sits in two slots; one on the bottom, and one on the left edge.

    • Slide LCD screen from the two slots.

    • Do not attempt to completely remove the screen, as it is still attached to the camera.

    Traduire

  8. To remove the LCD screen, detach the orange cable from the board. If needed, replace the LCD screen. If needed, replace the LCD screen.

    • To remove the LCD screen, detach the orange cable from the board.

    • If needed, replace the LCD screen.

    Traduire

  9. Remove the two screws holding down the steel back plate. Remove steel back plate.

    • Remove the two screws holding down the steel back plate.

    • Remove steel back plate.

    Traduire

  10. Now remove the plastic plate that covers the motherboard. Now remove the plastic plate that covers the motherboard.

    • Now remove the plastic plate that covers the motherboard.

    Traduire

  11. Warning: Electric Shock From this point on, hold the camera by the chrome edges ONLY. Capacitors store electric charge even if the batteries are removed. Remove the blue cable.

    • Warning: Electric Shock From this point on, hold the camera by the chrome edges ONLY. Capacitors store electric charge even if the batteries are removed.

    • Remove the blue cable.

    Traduire

  12. Disconnect the flash cable (black and white wires) before completely removing the front case. Gently start to remove the case.

    • Disconnect the flash cable (black and white wires) before completely removing the front case.

    • Gently start to remove the case.

    • Once the cable is free, set aside the front case.

    Traduire

  13. The speaker should now be clearly seen on the underside of the camera. Gently unplug the speaker from the motherboard.

    • The speaker should now be clearly seen on the underside of the camera.

    • Gently unplug the speaker from the motherboard.

    • Replace the speaker.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 6 autres contributeurs

Thomas

Membre depuis le 14/04/2010

124 Réputation

6 tutoriels rédigés

Badges: 11

+ 8 badges supplémentaires

Équipe

Cal Poly, Team 15-50, Garner Spring 2010 Membre de l'équipe Cal Poly, Team 15-50, Garner Spring 2010

CPSU-GARNER-S10S15G50

5 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 6

Total : 3,316