Sony Cyber-shot DSC-W730 Flash Capacitor Replacement

Introduction

Once you have removed the cover the capacitor (a black cylinder that has 330v capacity) will be attached to the circuit board by a thin ribbon. Be careful with the ribbon.

Ce dont vous avez besoin

Étape 1 Removing the Case

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Removing the Case: étape 1, image 1 de 3

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Removing the Case: étape 1, image 2 de 3

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Removing the Case: étape 1, image 3 de 3

Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

Traduire

Étape 2

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement: étape 2, image 3 de 3

Take off the front part of the case with a plastic opening tool.

Traduire

Étape 3

Pull off the two silver side pieces on the left and right sides.

Traduire

Étape 4

Remove the main back piece. It should easily lift off.

Traduire

Étape 5

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement: étape 5, image 3 de 3

Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

Traduire

Étape 6 Flash Capacitor

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Flash Capacitor: étape 6, image 1 de 3

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Flash Capacitor: étape 6, image 2 de 3

Sony Cyber-shot DSC-W730 Flash Capacitor Replacement, Flash Capacitor: étape 6, image 3 de 3

Lift the capacitor out and gently pull it away from the control board to unplug the ribbon attached to the side of the circuit board. Be careful not to bend the ribbon.

Traduire