Introduction

This guide shows how to replace the lens assembly that may not be working properly.

Slide the gray switch from lock to open position.
  • Slide the gray switch from lock to open position.

Ajouter un commentaire

Pull down on the blue tab to release the battery.
  • Pull down on the blue tab to release the battery.

Ajouter un commentaire

  • Use a PH00 screwdriver to remove the five 3.5 mm screws.

  • Use a PH00 screwdriver to remove the two 2.5 mm screws.

Ajouter un commentaire

  • Pry apart the case gently using a plastic opening tool.

Ajouter un commentaire

  • Pry back the panel to the right of the screen using a plastic opening tool.

Ajouter un commentaire

  • Working on the left side of the screen, pry the metal panel off from the motherboard housing using a plastic opening tool.

Ajouter un commentaire

  • Pull out the ZIF cable from the motherboard.

  • When removing the ZIF cable, pull it straight out to avoid damaging the cable.

Ajouter un commentaire

  • Unpin the ZIF cable by lifting the cable towards the top of the camera while pulling up towards yourself.

  • Pull the ZIF cable out.

Ajouter un commentaire

  • Lift the lens out of the case.

  • Pull out the ZIF cable.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kate Glazer

Membre depuis le 20/03/2018

579 Réputation

5 tutoriels rédigés

Équipe

IUPUI, Team S6-G3, Baechle Spring 2018 Membre de l'équipe IUPUI, Team S6-G3, Baechle Spring 2018

IUPUI-BAECHLE-S18S6G3

3 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 13

Total : 70