Introduction

If the device is having trouble reading disks, the laser may need to be replaced.

Remove the five exposed 7.9 mm phillips screws with the spudger.
  • Remove the five exposed 7.9 mm phillips screws with the spudger.

  • Punch through the warranty sticker with the spudger and remove the screw underneath.

Ajouter un commentaire

Remove the rubber feet with the screwdriver.
  • Remove the rubber feet with the screwdriver.

  • Remove the screws that the rubber feet were covering.

Ajouter un commentaire

  • Lift up the cover gently.

  • The tray is still connected to the base with wires.

Ajouter un commentaire

  • Remove the wires with tweezers by gently pulling on the base they are attached to.

Ajouter un commentaire

  • Remove the large connector.

  • Remove the small connector.

Ajouter un commentaire

  • Remove Philips screws with #0 Philips Screwdriver.

Ajouter un commentaire

  • Lift up the black piece connected to the wires.

  • Lift gently because ribbon cable is attached to bottom.

Ajouter un commentaire

  • Unlock the lock clip

Ajouter un commentaire

  • Remove the T6 screws with the T6 screwdriver.

Ajouter un commentaire

  • Gently pull rods out with tweezers.

  • Be sure the laser is out of the way so that the rods can be removed.

Ajouter un commentaire

  • Be careful when removing the rods because a fragile metal piece may break.

  • Pull laser off of the rods.

Ajouter un commentaire

  • Insert wisdom here.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Oliver Woolsoncroft

Membre depuis le 20/01/2012

69 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 11-21, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 11-21, Maness Winter 2012

CPSU-MANESS-W12S11G21

4 membres

5 tutoriels rédigés

where do I buy the lens?

mnmmacd - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 4

30 derniers jours : 11

Total : 4,015