Introduction

If the monitor or screen is broken, the monitor needs to be detached from the device.

Remove the five exposed 7.9 mm phillips screws with the spudger.
  • Remove the five exposed 7.9 mm phillips screws with the spudger.

  • Punch through the warranty sticker with the spudger and remove the screw underneath.

Ajouter un commentaire

Remove the rubber feet with the screwdriver.
  • Remove the rubber feet with the screwdriver.

  • Remove the screws that the rubber feet were covering.

Ajouter un commentaire

  • Lift up the cover gently.

  • The tray is still connected to the base with wires.

Ajouter un commentaire

  • Remove the wires with tweezers by gently pulling on the base they are attached to.

Ajouter un commentaire

  • Use your hand to remove the small back cover.

Ajouter un commentaire

  • Remove the two 0.473" pan head screws as shown circled in the picture

Ajouter un commentaire

  • The screen should now detach from the main device.

  • The screen will still be connected by the wires

Ajouter un commentaire

  • Remove the wires attached to the white base by using the tweezers

Ajouter un commentaire

  • Do the same with the wires attached to the black base.

Ajouter un commentaire

  • The screen should now be completely separated from the main device.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Ward

Membre depuis le 20/01/2012

39 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 11-21, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 11-21, Maness Winter 2012

CPSU-MANESS-W12S11G21

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 8

Total : 2,541