Aller au contenu principal

Introduction

This guide will assist you in removing the screen from your Sony Ericsson T68i.

Pièces

Aucune pièce spécifiée.

  1. Remove the battery from the back. Remove the battery from the back.
    • Remove the battery from the back.

  2. Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips. Do not bend it too far down, or else you risk breaking the two bottom clips. Do not bend it too far down, or else you risk breaking the two bottom clips.
    • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

    • Do not bend it too far down, or else you risk breaking the two bottom clips.

  3. Unscrew all four Torx T6 screws. Keep in a safe place. Keep in a safe place.
    • Unscrew all four Torx T6 screws.

    • Keep in a safe place.

  4. Fix Kits pour Android

    Remplacer l'écran ou la batterie est à portée de kit !

    Acheter maintenant

    Fix Kits pour Android

    Remplacer l'écran ou la batterie est à portée de kit !

    Acheter maintenant
  5. After removing the screws, the two halves will separate. If not, then pry them gently apart. After removing the screws, the two halves will separate. If not, then pry them gently apart. After removing the screws, the two halves will separate. If not, then pry them gently apart.
    • After removing the screws, the two halves will separate. If not, then pry them gently apart.

  6. Remove the circuit board and screen from the device. Use your T6 to remove the 4 screws. Use your T6 to remove the 4 screws.
    • Remove the circuit board and screen from the device.

    • Use your T6 to remove the 4 screws.

  7. Remove the board and screen. Remove the board and screen. Remove the board and screen.
    • Remove the board and screen.

  8. Carefully remove the plastic clips holding the screen on the board. Carefully remove the plastic clips holding the screen on the board. Carefully remove the plastic clips holding the screen on the board.
    • Carefully remove the plastic clips holding the screen on the board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tim Dascomb

Membre depuis le 13/04/2010

135 Réputation

7 tutoriels rédigés

Équipe

Cal Poly, Team 26-34, Regan Spring 2010 Membre de l'équipe Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 membres

13 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,586