Introduction

This guide is going to show you how to replace a cracked or scratched glass screen. This guide only shows how to replace the glass, not the LCD screen.

Place the phone with the back facing up. Remove the back cover and the battery.
  • Place the phone with the back facing up. Remove the back cover and the battery.

Ajouter un commentaire

Remove the 5mm screws from back of the phone, image indicates where they are. There should be 8 screws. Use a T-6 bit.
  • Remove the 5mm screws from back of the phone, image indicates where they are. There should be 8 screws. Use a T-6 bit.

Ajouter un commentaire

  • Use a case opening tool to release clips holding together the case. It should be easier starting at the bottom right side of the phone, as indicated in the image. Insert the tool and run it down the side of the phone, using a prying motion to pull it apart.

Ajouter un commentaire

  • Case should be in two pieces. Take the side indicated in the left side of the image and put it out of the way.

Ajouter un commentaire

  • Insert a flat head screw driver under the two clips and pry up. The chip should come loose with just a ribbon cable holding it to the rest of the phone.

Ajouter un commentaire

  • Flip the chip to the left and remove the ribbon cable from the rest of the phone using a flat head screw driver. Gently insert the screw driver under the cable and pry up.

Ajouter un commentaire

  • If the volume rocker and camera button haven't fallen off yet, remove them and put them off to the side. Using your fingers or a screwdriver, pull off the black plastic piece on the very top of the phone. This is the audio jack.

Ajouter un commentaire

  • Using a flat head screw driver, undo the ribbon cables connected to the phone. There should be two on the left, one on the right, and one on the top.

Ajouter un commentaire

  • Gently insert a flat head screw driver under the logic board and pry to remove it from the phone casing. There should be a notch where a screw driver can fit as indicated in the image.

Ajouter un commentaire

  • Logic board should be removed from the phone. Put it off to the side.

Ajouter un commentaire

  • Using a flat head screw driver, disconnect the glue holding the left ribbon cable to the phone. Once unglued, the cable should flip back and still be connected to the phone. Pull up the black plastic piece being pointed to in the image.

Ajouter un commentaire

  • Using a flat head screwdriver, pry up the board. Should have to pry from the left and from the right. Nothing is holding in the power button on the top of the phone, go ahead and remove it.

Ajouter un commentaire

  • The glass front can now be replaced. It appears that the front buttons, front plastic face, and the glass screen are all one piece.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order. The pieces need to be placed exactly back into the phone as they came out or else they won't fit together correctly.

Matt

Membre depuis le 29/10/2013

319 Réputation

2 tutoriels rédigés

Équipe

University of Maryland, Team 1-5, Shastany Fall 2013 Membre de l'équipe University of Maryland, Team 1-5, Shastany Fall 2013

UMD-SHASTANY-F13S1G5

2 membres

3 tutoriels rédigés

good evening

when I put my SD card in my xperia it not appear but when I place it in another mobile standard market

djidja - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 12

Total : 1,737