Réparez vos affaires Communauté Boutique

Sony H.ear On 2 Microphone Replacement

Introduction

Learn how to replace the microphones inside your Sony H.ear On 2!

Replacing noise canceling microphones requires minimal disassembly but will require you to solder 2 connections.

Note: Headphone symmetry allows for identical replacement procedure for microphone on left and right side.

Ce dont vous avez besoin

  1. Sony H.ear On 2 Microphone Replacement, Ear Cup: étape 1, image 1 de 2 Sony H.ear On 2 Microphone Replacement, Ear Cup: étape 1, image 2 de 2

    • Start by inserting the iFixit plastic opening tool in the crease between the hard plastic and the ear cup, and then gently apply pressure until it separates. You may need to repeat the process on back until it is completely separate.

    • This may take a considerable amount of pressure, but do not force it.

    Modifier

  2. Sony H.ear On 2 Microphone Replacement: étape 2, image 1 de 2 Sony H.ear On 2 Microphone Replacement: étape 2, image 2 de 2

    • Use the JIS #00 Screwdriver to remove the five 6.4 mm screws holding the back plastic cover in place.

    • Then, turn the ear cup over and carefully lift the plastic cap off to reveal the internal components of the left ear cup.

    • This same process can be repeated on the right ear cup as well. Be aware the right cup is connected to the rest of the headphones via ribbon cable.

    Modifier

  4. Sony H.ear On 2 Microphone Replacement, Noise Cancelling Microphone: étape 3, image 1 de 3 Sony H.ear On 2 Microphone Replacement, Noise Cancelling Microphone: étape 3, image 2 de 3 Sony H.ear On 2 Microphone Replacement, Noise Cancelling Microphone: étape 3, image 3 de 3

    • Use the iFixit plastic opening tool to lift the microphone out of its housing

    • Use gentle pressure to prevent damaging small wire connections

    Modifier

  5. Sony H.ear On 2 Microphone Replacement: étape 4, image 1 de 2 Sony H.ear On 2 Microphone Replacement: étape 4, image 2 de 2

    • Use soldering iron to desolder microphone wires from motherboard

    • Please see How to Solder and Desolder Connections before you attempt to use the soldering iron.

    • Note: Do not overheat joints while de-soldering to prevent board damage

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autres ont terminé cette réparation.

Auteur

avec 6 autres contributeurs

Justin Ramirez

Membre depuis le 04/15/19

127 Réputation

1 tutoriel rédigé

Badges: 6

+ 3 badges supplémentaires

Équipe

Cal Poly, Team S9-G11, Maness Spring 2019 Membre de l'équipe Cal Poly, Team S9-G11, Maness Spring 2019

CPSU-MANESS-S19S9G11

5 membres

16 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 7

30 derniers jours : 29

Total : 2,076