Introduction

To complete this guide, a soldering iron will be needed. You may want to have someone with soldering iron experience complete that step or watch some basic videos on how to use a soldering iron.

Unscrew two 5 mm Phillips #00 screws using a Phillips #00 screwdriver located on the bottom of the back of the device.
  • Unscrew two 5 mm Phillips #00 screws using a Phillips #00 screwdriver located on the bottom of the back of the device.

Ajouter un commentaire

Using a plastic opening tool, loosen the bottom portion of device.
  • Using a plastic opening tool, loosen the bottom portion of device.

Ajouter un commentaire

  • Using a plastic opening tool, loosen the top panel of the device.

Ajouter un commentaire

  • Remove two 3 mm Philips #00 screws using a Phillips #00 screwdriver located on the portion under the top panel of the device.

Ajouter un commentaire

  • Remove back plate from device.

Ajouter un commentaire

  • Peel back layer of tape.

  • Remove processor located below tape and down from the battery using tweezers and spudger.

Ajouter un commentaire

  • Using a prying tool, slide tool under the top portion of the battery.

Ajouter un commentaire

  • Remove sticker from battery connection.

Ajouter un commentaire

  • Use a soldering iron to remove wires from both red and black terminals.

How many volts battery is it? mhA?

sriranggan perumal - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Matthew Hintz

Membre depuis le 16/01/2015

315 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team 17-6, Watkins Winter 2015 Membre de l'équipe USF Tampa, Team 17-6, Watkins Winter 2015

USFT-WATKINS-W15S17G6

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 7

7 derniers jours : 41

30 derniers jours : 181

Total : 6,268