Menu 

Vos paramètres

Mon établi

Accédez rapidement aux tutoriels, aux pièces et aux réponses correspondant à vos appareils
Mon panier (US Store)

On dirait que votre panier est vide

Parcourez notre boutique

Sony Radio CD player and cassette player CFD-S05 Belt for the Tape Motor Replacement

Rédigé par : Ian Nussman (et 4 autres contributeurs)
  • Commentaires : 1
  • Favoris : 0
  • Réparations terminées : 2

Difficulté

Modérée

Étapes

11

Sections

2

Drapeaux

3

Bullets!

Puces !

Une bonne utilisation des balises, de la couleur et/ou du format des puces donnera de la clarté à ce tutoriel !

Markup Mishap

Problème de balisage

Ce tutoriel nécessite de meilleures balises. Améliorez-le par des corrections ou des annotations de balisage.

Better Introduction

Meilleure introduction

Améliorez ce tutoriel en complétant ou modifiant l'introduction.

Introduction

Outline what you are going to teach someone how to do.

Outils

Acheter ces outils

Pièces

Aucune pièce nécessaire.

  1. Unscrew the screws on the top of the radio.

    • Unscrew the screws on the top of the radio.

    Traduire

  2. Open the CD and cassette doors and remove the screws in the compartments. To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

    • Open the CD and cassette doors and remove the screws in the compartments.

    • To open the CD door push on the bottom left corner of the CD door. To open the cassette door push the button that is to the left of the pause button.

    Traduire

  3. Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

    • Flip the radio upside down and remove the battery cover. Unscrew the one screw below the batteries.

    Traduire

  4. Remove the top of the radio enough to access the wires for removal.

    • Remove the top of the radio enough to access the wires for removal.

    • Do not forcefully remove the whole top piece of the radio! There will be wires connected to the top cover and circuit board.

    Traduire

  5. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Avez-vous jamais réparé quelque chose ? C’est génial.

    Share your repair story with #ImAGenius

    Nous sommes tous des génies

    Share your repair story with #ImAGenius

  6. Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected

    • Remove all of the wires that are connected to both the circuit board and the underside of the top of the radio by pulling them where they are connected

    • This should include three sets of red and white wires, one set of white wires, one set of black wires, and two ribbon wires. Some cannot be disconnected from the top piece of the radio. Disconnect these plugs from the circuit board.

    Traduire

  7. Locate the motor of the radio on the underside of the top of the radio.

    • Locate the motor of the radio on the underside of the top of the radio.

    Traduire

  8. Unscrew the screw holding the motor to the top of the radio.

    • Unscrew the screw holding the motor to the top of the radio.

    Traduire

  9. Lift up the motor.

    • Lift up the motor.

    • Don't lift too high because the motor stand will break.

    Traduire

  10. Unhook the larger band from under the motor and remove it.

    • Unhook the larger band from under the motor and remove it.

    Traduire

  11. Replace the band by hooking it beneath the motor.

    • Replace the band by hooking it beneath the motor.

    Traduire

  12. Push the motor back down and screw it into place.

    • Push the motor back down and screw it into place.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Auteur

avec 4 autres contributeurs

Ian Nussman

Membre depuis le 25/10/2013

827 Réputation

6 tutoriels rédigés

Badges: 11

+ 8 badges supplémentaires

Équipe

University of Maryland, Team 2-5, Gulbrandsen Fall 2013 Membre de l'équipe University of Maryland, Team 2-5, Gulbrandsen Fall 2013

UMD-GULBRANDSEN-F13S2G5

2 membres

6 tutoriels rédigés

Un commentaire

Ajouter un commentaire

I'm worried about removing wires. How do you put them back? Doesn't that take some kind of special equipment/glue?

Carolyn Farley - Réponse

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 10

30 derniers jours : 22

Total : 2,629