Réparez vos affaires Communauté Boutique

Sony VAIO VPCEC1M1E Keyboard Replacement

Introduction

Use this guide to remove and replace the keyboard of your Sony VAIO VPCEC1M1E Laptop.

Disclaimer: iFixit staff has found this guide to be an interesting look at the device, but it is not indicative of the best way to perform repair. Use caution in following the guide and read all steps before you attempt the repair.

Ce dont vous avez besoin

  1. Sony VAIO VPCEC1M1E Keyboard Replacement, Keyboard: étape 1, image 1 de 1

    • Remove the following color-coded screws:

    • These screws secure the RAM and hard drive covers, respectively.

    • These screws secure the optical drive to the lower case of the laptop.

    • The various other screws highlighted in the picture are unnecessary to remove and should be done at your own discretion.

    Modifier

  2. Sony VAIO VPCEC1M1E Keyboard Replacement: étape 2, image 1 de 1

    • Remove the following screws:

    • Five screws highlighted in orange.

    • Two screws highlighted in blue.

    • Pry the hard drive connector upwards from its socket on the logic board.

    Modifier

  4. Sony VAIO VPCEC1M1E Keyboard Replacement: étape 3, image 1 de 1

    • Release the highlighted clips to remove the upper case of the keyboard.

    Modifier

  5. Sony VAIO VPCEC1M1E Keyboard Replacement: étape 4, image 1 de 3 Sony VAIO VPCEC1M1E Keyboard Replacement: étape 4, image 2 de 3 Sony VAIO VPCEC1M1E Keyboard Replacement: étape 4, image 3 de 3

    • Flip up the retaining flap (highlighted in red) on the keyboard ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap and not the socket itself.

    • Pull the keyboard ribbon cable straight out of its socket toward the front edge of the laptop.

    Modifier
Ligne d'arrivée

7 autres ont terminé cette réparation.

Auteur

avec 7 autres contributeurs

Stephan

Membre depuis le 08/20/11

199 Réputation

1 tutoriel rédigé

Badges: 7

+ 4 badges supplémentaires

3 commentaires

Very useful, thank you. A real pain to do though without snapping the plastic tabs on the upper case.

Eddie B - Réponse

OMG... guys, you need just unscrew FOUR screws on the bottom (two orange circles on the same level that yellow sticker and two orange-circled screws in the middle of left and right side) and then pop the keyboard up with knife, etc, and disconnect the cable.

Paul G - Réponse

agree with Paul G. you don’t need to remove all the plastic case to change the keyboard

Pierret -

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 7

30 derniers jours : 23

Total : 23,003