Introduction

This guide covers the Sony Xperia XZ Premium front camera removal. This process involves unscrewing two screws and removing part of the frame to reach the camera.

Pièces

Aucune pièce nécessaire.

Place a heated iOpener on the back panel of the phone to melt the adhesive inside.
  • Place a heated iOpener on the back panel of the phone to melt the adhesive inside.

  • The iOpener or your desired heat source can be very hot and can heat up the phone, so make sure you do not burn yourself.

  • Follow this guide for directions on using the iOpener.

Ajouter un commentaire

Slide a thin plastic card under the back panel and around the perimeter of the phone to remove the adhesive.
  • Slide a thin plastic card under the back panel and around the perimeter of the phone to remove the adhesive.

Ajouter un commentaire

  • Take hold of the back panel with your fingers and remove.

Ajouter un commentaire

  • Remove the two bottom left 3.9 mm Phillips #000 screws.

Ajouter un commentaire

  • Insert the spudger under the bottom left frame and lift, try to lift vertically to wedge it out.

Ajouter un commentaire

  • Grab hold of the bottom left frame and lift out carefully.

Ajouter un commentaire

  • Insert a spudger under the tab above the camera and lift to disconnect it.

Ajouter un commentaire

  • Grab hold of the tab with your fingers.

Ajouter un commentaire

  • Lift the camera from the phone by the tab.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Gelene Amog

Membre depuis le 18/04/2018

759 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S18-G2, Livingston Spring 2018 Membre de l'équipe Cal Poly, Team S18-G2, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G2

5 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 16

30 derniers jours : 59

Total : 209