Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Heat along the edges of the back cover using a heat gun to soften the glue.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Attach the small suction cup to the back cover near the bottom of the phone.
-
Pull up on the suction cup and insert the plastic opening tool in between the back cover and the rest of the phone.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Move the spudger around the edge of the back cover to separate it from the black adhesive.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Carefully disconnect the battery from the logic board by using the plastic spudger as a lever.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single 1 x 3.0 mm screw holding the battery in using the JIS #00 screwdriver.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pry the battery up from the ends using the plastic spudger until the battery pops out of the enclosure.
-
Annulation : je n'ai pas terminé ce tutoriel.
12 autres ont terminé cette réparation.
3 commentaires
is there any reliable source for good replacement battery purchase?
NFC Antenna. You should carefully transplant it to new battery, in case your new battery is without one (what is the case for most 3rd party batteries available)