Aller au contenu principal

Introduction

If you need to replace either one of the two top buttons, or trigger buttons, on the remote for the Spin Master Boxer Bot, follow this guide. If you only wanted access to replacing remote joysticks, this guide will work as well. To follow this replacement guide you will need Size 00 Philips Screwdriver, as well as a flat metal opening tool, the Jimmy.

Pièces

Aucune pièce spécifiée.

  1. Lay the remote flat on your work space, with joysticks facing you.
    • Lay the remote flat on your work space, with joysticks facing you.

  2. Remove both joysticks by gripping under circular knob and gently pulling towards you.
    • Remove both joysticks by gripping under circular knob and gently pulling towards you.

    • The joysticks should detach without much effort.

  3. Use the Phillips #00 Screwdriver to remove 4mm screw on the center battery panel.
    • Use the Phillips #00 Screwdriver to remove 4mm screw on the center battery panel.

    • Remove the batteries from the remote and set it to side.

    • Use the same screwdriver to remove all four 4mm screws on back panel.

  4. Insert the Jimmy in between the top panel and the bottom panel. Gently use the Jimmy to separate both plastic panels from each other.
    • Insert the Jimmy in between the top panel and the bottom panel.

    • Gently use the Jimmy to separate both plastic panels from each other.

    • Pull the panels apart and set bottom piece on workbench.

  5. Pinch the trigger between index finger and thumb, and lift up, away from circuit board. Inspect the square button attached to circuit board to ensure functionality. If there is an issue with connection, a new circuit boards may be required.
    • Pinch the trigger between index finger and thumb, and lift up, away from circuit board.

    • Inspect the square button attached to circuit board to ensure functionality. If there is an issue with connection, a new circuit boards may be required.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Lauren Roide

Membre depuis le 16/04/2019

727 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S1-G1, Maness Spring 2019 Membre de l'équipe Cal Poly, Team S1-G1, Maness Spring 2019

CPSU-MANESS-S19S1G1

4 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 3

7 derniers jours : 4

30 derniers jours : 10

Total : 450