Aller au contenu principal

Introduction

If Spin Master Boxer is not making any noises, follow this guide to replace speaker. The speaker is located inside of robot, and requires a Size 00 Philips Screwdriver to complete replacement, and requires soldering to remove the speaker.

Pièces

Aucune pièce spécifiée.

  1. Set Spin Master Boxer on your workspace so that the bottom panel faces upwards.
    • Set Spin Master Boxer on your workspace so that the bottom panel faces upwards.

  2. Using a Phillips #00 screw driver, unscrew the four 4mm screws in each corner of the bottom panel.
    • Using a Phillips #00 screw driver, unscrew the four 4mm screws in each corner of the bottom panel.

  3. Carefully remove the bottom panel of the Spin Master Boxer by lifting up, away from the main body of robot.
    • Carefully remove the bottom panel of the Spin Master Boxer by lifting up, away from the main body of robot.

  4. While holding onto the axels of the wheels, gently pull the top panel of the robot away from its body. Be aware when removing the panel that multiple wires connect it to the body of the Spin Master Boxer.
    • While holding onto the axels of the wheels, gently pull the top panel of the robot away from its body.

    • Be aware when removing the panel that multiple wires connect it to the body of the Spin Master Boxer.

  5. Remove the plastic screen from the body of the robot. It should come off easily as it is not attached by anything.
    • Remove the plastic screen from the body of the robot. It should come off easily as it is not attached by anything.

  6. Using a Phillips #00 screwdriver, unscrew the two 3mm screws connecting the black speaker cover to the top panel. Using a Phillips #00 screwdriver, unscrew the two 3mm screws connecting the black speaker cover to the top panel.
    • Using a Phillips #00 screwdriver, unscrew the two 3mm screws connecting the black speaker cover to the top panel.

  7. Remove the speaker cover and you will be left looking at the speaker.
    • Remove the speaker cover and you will be left looking at the speaker.

    • The speaker is soldered onto the top panel so additional measures must be taken to completely remove it. See Comment souder et dessouder des connexions

Conclusion

To reassemble your device, follow these instructions in reverse order.

Lauren Roide

Membre depuis le 16/04/2019

727 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team S1-G1, Maness Spring 2019 Membre de l'équipe Cal Poly, Team S1-G1, Maness Spring 2019

CPSU-MANESS-S19S1G1

4 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 9

Total : 582