Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Flip the Swagtron so that the footpads are facing the ground.
-
Unscrew the sixteen 9.4 mm Phillips #1 machine screws on the side of the Swagtron that is now facing upwards.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Slowly lift the backside cover.
-
Detach the four cables connected to the cover by pinching the connector clips and pulling the cables out:
-
Three cables on the motherboard side.
-
Two red cables with white connectors and one white cable with a white connector.
-
One yellow cable with a black connector on the battery side.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Detach the four cables connecting the gyroscope to the hoverboard by pinching the connector clips and pulling the cables out:
-
Three red and black cables with white connectors.
-
One multicolored cable with a black connector.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Uncrew the four 7.2 mm Phillips #1 self-drilling screws connecting the blue gyroscope to the white plastic holding piece.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Cut the plastic cable tie holding the cables together with utility scissors.
-
Disconnect the blue/green cable from the blue/white cable by pinching the connector clips and pulling the cables apart.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently lift the blue gyroscope off of the white plastic holder piece.
-
Annulation : je n'ai pas terminé ce tutoriel.
3 autres ont terminé cette réparation.